| السلسلة | (C)TTH0505M-1T |
| الطراز | (C)TTH0505M-1T |
| العلامة التجارية | MORNSUN |
| Inductance(L) ① | pin 1 to pin 2: 60 μH; pin 4 to pin 3: 70 μH; pin 1 to pin 2: 0.10 μH |
| DCR Isolation | Ω; pin 4 to pin 3: 0.20; Primary-Secondary Electric Strength Test for 1: 5000 VAC; minute with a leakage current of 1mA max.: 6000 VDC |
| Insulation resistance | 1000 MΩ @Input-output, insulation voltage 500VDC |
| سعة العزل | 3 pF (Primary-Secondary capacitance at 100kHz/0.1V) |
| Voltage-Time ② | 11 uVs (12V input) |
| رطوبة التخزين | 5–95 %RH (Non-condensing) |
| Operating Temperature ③ | -40 to +125℃ |
| Storage Temperature ④ | -55–+125 time≤150s; Peak temp.≤245℃, maximum duration time≤150s |
| Reflow Soldering Temperature ⑤ | over 217℃. |
| مادة الغلاف | Black plastic; flame-retardant and heat-resistant (UL94 V-0) |
| الأبعاد | 12.6 x 8 x 5.4mm |
| الوزن | 0.6g(Typ.) |
| طريقة التبريد | Free air convection |
| Material certification Material | UL No. |
| Wire | E211989 |
| البكرة | E41429 |
| Phase Diagram | Table 1; Turns Ratio (Np:Ns); Part No. N1a: N2a; TTF1220-2T 1: 1.10 (Typ.); Fig. 1 |
| Application Circuit | Table 2: Recommended parameters; IC1 SCM1208; C1; 1µF/25V; C2; IC2 SCM2306; R8 10kΩ; Fig. 2 Application circuit of TTF1220-2T |
| 1. If it is required to further reduce | input and output ripple, the capacitance of C1 and C2 can be increased properly if required, and should |
| be connected close to the pin | terminal of the module. |
| 2. In order to ensure the converter | can work reliably with high efficiency, the minimum load should not less than 1% rated load when it is |
| used. If the needed power is | indeed small, please parallel a resistor on the output side ( The sum of the efficient power and resistor |
| consumption power is not less | than 1%). |
| Dimensions and | Recommended Layout |
| 1. For additional information | on Product Packaging please refer to www.mornsun-power.com. Roll packaging bag number: 58210410; |
| 2. Unless otherwise specified, | parameters in this datasheet were measured under the conditions of Ta=25℃, humidity<75%RH, 100kHz and |
| 3. All index testing methods in | this datasheet are based on our company corporate standards; |
| 4. We can provide other analog | transformer customization service, please contact our technicians directly for specific information; |
| 5. Our products shall be classified | according to ISO14001 and related environmental laws and regulations, and shall be handled by qualified |
| Address: No. 8 Nanyun 4th Road, | Huangpu District, Guangzhou, China |
| Tel: 86-20-38601850 | Fax: 86-20-38601272 E-mail: info@mornsun.cn www.mornsun-power.com |